With the development of technology, with the advantages of convenience and efficiency, automatic baling machine in the production of more and more widespread. However, there are often some failures in the use of the following small summary of several common problems and solutions to automatic baling machine.

Automatic baler several common problems and solutions 

A, automatic baler with a strange sound

This is a very common problem, this problem is mainly the purchase of new machines and machines that run for a long time, this is because the machine parts lack of lubricant, the need for users to check themselves to see if the machine parts, bearings, pulleys lack of lubricant caused by wear and tear, if not, you need to contact the maintenance staff to check;

Second, the card tape

The tape can not run, stuck in the middle of the rollers, or something jammed can not be removed, resulting in a jammed belt, then you need to technical personnel on the scene, remove foreign objects.

Third, the items are not bundled tightly

this situation may be in the beaten tape is the placement of the packaging is a problem, you need to adjust the position of the packaging, there is a packaging is too small, also caused by this situation, if not, you need to contact the maintenance staff;

Fourth, the bundle is not cut after tightening the tape

Will cause this situation for the following reasons: 1. machine elasticity jump a little tight; 2. machine heating cutting knife is bad, which needs to contact the maintenance staff for repair; 3. slipping piece or slipping belt has oil, must be removed to wipe off the oil

Five, the baler is not out of the belt

This type of failure is still relatively common, the operator should check the length of the belt, and then see if the process of wearing the belt is correct; if not, see if the roller near the jammed foreign objects.

Six, packing tape bandage

There are two reasons for this situation: 1, the temperature of the heating head is too high, the temperature is too high will lead to the melting of the strapping, bonding time is too long, in the not yet bonded is, it is cut, resulting in bandage, which needs to contact the maintenance staff; 2, the machine's strapping too much tension, which can be adjusted, too much tension, in the strapping is not yet bonded, too much tension, resulting in the collapse of the band, the need for maintenance staff debugging;

Seven, strapping can not be glued

Packing tape can not be glued may be the reason for hot head:

First, to determine whether the strapping has been hot traces, if not, it means that the ironing head simply no temperature, it is necessary to see whether the ironing head wire off or ironing head damage occurs.

Secondly, if the strapping has hot traces but not fully bonded, then first look at whether the temperature of the ironing head is too low, if the temperature is not low, then it is possible that the ironing head is used for too long, the surface attached too many strapping debris, the need for manual cleaning.